Inserting heated tobacco sticks in the IQOS 3
Make sure you don't twist the tobacco stick while inserting it into your IQOS 3 Holder, this twisting motion can damage the heating blade.
CONTINUE
Select your device
1. Tap the button on your IQOS 3 Pocket Charger to check your battery level. When you see the lights, it's ready to use. If your Pocket Charger doesn't power up, hold down the button for four seconds or plug your device into a power outlet using an IQOS AC adaptor and cable.
2. Open the Pocket Charger door, insert the Holder into the charger, then close. A flashing light at the top of your device will let you know it’s charging.
3. When it's ready to use, gently insert a HEETS stick, without twisting, into your Holder. Then press and hold the Holder button. One vibration and lights pulsing slowly means it’s getting ready. Two vibrations and both status lights on mean it's ready to use.
4. If your Holder light starts to fade, your IQOS 3 needs a charge. Remove the HEETS stick, and recharge using the IQOS AC adaptor and cable.
1. Take out your used HEETS tobacco stick.
2. Put your IQOS 3 Holder in the Pocket Charger and close the door. The bar lights at the top will let you know the charge level. When you see a small light flash, your Holder is charging.
3. After a few minutes, the small light will stop flashing. Your Holder is now charged and ready to use.
4. When the battery lights on your Pocket Charger fade, plug it into a power outlet using your IQOS cable and AC power adaptor to recharge.
1. Wait for your IQOS 3 Holder to cool down then slide the cap off.
2. Tap out any loose tobacco from inside your Holder then insert the cleaning tool. Once in, gently twist two or three times before carefully removing it.
3. Clean your device using the cleaning sticks as often as you can. Remember to avoid the blade, and don’t forget to clean the cap top to bottom too. A cleaner device makes for a better taste experience.
IQOS 3 Tips
Make sure you don't twist the tobacco stick while inserting it into your IQOS 3 Holder, this twisting motion can damage the heating blade.
Remember to keep your IQOS 3 Pocket Charger battery charged daily. Your IQOS 3 will charge faster if you plug it to a wall power outlet
You only need to press the IQOS 3 Holder button once to activate the heating blade. Once the light indicator goes from blinking to steady, it’s ready. (pressing the button again may turn it off.)
Still have questions about IQOS?
We are available to help you through various channels.
Visit our support page and chat to an IQOS expert. Available everyday from 09h-00h.
Go to Facebook pageYour question might have already been asked before. Browse our FAQs to see if there’s an answer waiting for you.
Look through our FAQ