![How to insert a HEET correctl](https://d5nohihqdh60l.cloudfront.net/images/kura/support/first-steps/iqos3duo/LearnMoreIQOS3DUO_Tile5_Grid1_NoPeopleNoHeets_Desktop@2x.jpg?d=0)
Inserting heated tobacco sticks in the IQOS 3 DUO
Don't twist the tobacco stick while inserting it into your IQOS 3 Holder, this twisting motion can damage the heating blade.
CONTINUE
Select your device
1. Tap the button on your IQOS 3 DUO Pocket Charger to check your battery level. If it’s low, plug your device into a power outlet using an IQOS AC adaptor and cable.
2. Press the button at the top of your Pocket Charger for four seconds to turn it on. Then check the status lights on your IQOS 3 DUO Holder to see its battery level. Two lights mean it’s fully charged (ready for two uses). One light means it’s ready for one use. No lights mean no power and it’s time to recharge the Holder.
3. Gently insert a HEETS stick, without twising, into your Holder. Then press and hold the holder button. One vibration and lights pulsing slowly means it’s getting ready. Two vibrations and both status lights on mean it's ready to use.
4. When you feel another two vibrations, your IQOS time is nearly up. Slide open the Holder, remove the HEETS stick, and slide the Holder shut then tap the Holder button to see its status. Remember that one light means you only have one use left, so you'll need to put back into the Pocket Charger after next time.
5. When your Holder is in the Poket Charger, flashing lights mean itss charging. When both lights are on and stay on, your Holder is ready to take out.
1. Tap the button on your IQOS 3 DUO Pocket Charger button to check the battery level. A flashing light at the top means the battery’s low and you'll need to plug the Pocket Charger into a power outlet using an IQOS AC adaptor and cable. A flashing light means the battery’s now charging. When the status bar is full, your device is fully charged and good for up to 20 uses.
2. Check the status lights on your IQOS 3 DUO Holder. Two lights mean your Holder's fully charged and ready for two uses. One light means you only have one use left. No lights means there’s no battery power and it’s time to recharge.
3. Slide open your Holder, remove the HEETS stick, slide the Holder shut and insert the Holder into the Pocket Charger. If two small lights start flashing on the top of the Pocket Charger, your Holder is charging. When they stop flashing, your Holder is good and ready to use.
1. Wait for your IQOS 3 DUO Holder to cool down then slide the cap off.
2. Tap out any loose tobacco from inside your Holder then insert the cleaning tool. Once in, gently twist two or three times before carefully removing it.
3. Clean your device as often as you can. Remember to avoid the blade, and don’t forget to clean the cap top to bottom too. A cleaner device makes for a better taste experience.
IQOS 3 DUO Tips
Don't twist the tobacco stick while inserting it into your IQOS 3 Holder, this twisting motion can damage the heating blade.
Remember to keep your IQOS 3 DUO Pocket Charger battery charged daily. Try to charge it at the same time as you charge your phone. Charging is faster if plugged to a wall outlet than to a laptop’s USB ports.
Press and hold the IQOS 3 DUO Pocket Charger button for 4 seconds, then release. The holder and pocket charger status lights will turn on slowly. To charge the holder, slowly insert it into the pocket charger, then close the door.
Still have questions about IQOS?
We are available to help you through various channels.
Visit our support page and chat to an IQOS expert. Available everyday from 09h-00h.
Go to Facebook pageYour question might have already been asked before. Browse our FAQs to see if there’s an answer waiting for you.
Look through our FAQ